Manual wire rope hoist: shear pins -Where are the spare shear pins? ?
HIT-06/10 in jaw opening lever
HIT-16/32 in carrying handle
What are the dimensions of the shear pins?
Ø 5,5 mm x L= 20 mm / HIT-06
Ø 7,0 mm x L= 22 mm / HIT-10/T-15
Ø 7,5 mm x L= 29 mm / HIT-16/32
Ø 6,0 mm x L= 14 mm / T-7
Manual wire rope hoist: rope diameter?
HIT-06 = Rope Ø 6,4 mm
HIT-10 = Rope Ø 8,4 mm
HIT-16 = Rope Ø 11,2 mm
HIT-32 = Rope Ø 16,2 mm
T-7 = Rope Ø 8,4 mm
T-15 = Rope Ø 11,2 mm
T-35 = Rope Ø 16,2 mm
Manual wire rope hoist: standard length of wire rope ?
HIT-06 = 10 m without reel
HIT-10 = 20 m on reel
HIT-16 = 20 m on reel
HIT-32 = 10 m on reel
Motor-driven rope pulling machines: without STIHL engine ?
Can rope pulling machines HIT-TRAC 8 B or 16 B be bought without STIHL engine?
No - The motor driven rope pulling machines HIT-TRAC 8 B and 16 B are sold only with STIHL engines fitted.
The engines are specially produced and converted to suit our machines.
Can rope pulling machines HIT-TRAC 8 B or 16 B be purchased with other petrol engines? ?
No – we supply the HIT-TRAC 8 B and 16 B with STIHL engines only.
Motor-driven rope pulling machines: rope pulling speed of HIT-TRAC 16 E ?
10 m/min
The HIT-TRAC 16 E can also be supplied with a variable control. This enables the speed to be adjusted continuously between 2-8 m/min.
Motor-driven rope pulling machines: HIT-TRAC 16 E with single phase motor?
No – only available with a 3-phase AC drive motor 400 V / 50 Hz 6,8 A
Motor-driven rope pulling machines: pulling in both directions
Can the HIT-TRAC be used to pull in both directions?
No – To pull in the other direction, the rope must be inserted again in such a way that the load rope is drawn past the pressure roller.
Motor-driven rope pulling machines: passenger transport ?
Ist der HIT-TRAC für Personentransport zugelassen?
Is the HIT-TRAC licensed for passenger transport?
No - The HIT-TRAC is licenced for pulling, lifting and lowering of loads only.
In order to use the machines for passenger transport an additional safety device is required.
e.g. an interceptor or personal fall protection equipment
Rope pulleys: breaking load ?
What is the breaking load of rope pulleys?
The information on the load always refers to the nominal rope pulley load values. These are calculated with a quadruple safety margin in every case.
Repairs?
Where can the machines be repaired?
In our factory in Trubschachen/Switzerland. We do have a test bench with the required test loads.
Inspection Interval?
How frequently must the wire rope hoist or rope pulling machine be checked by an expert?
Every 2 years